Researchers at Nanyang Technological University have developed ultra-fast charging batteries that last 20 years.
Credit: Nanyang Technological University

If you’re tired of spending more time charging your phone than actually using it, a team of researchers out of Singapore have some good news for you. The group from Nanyang Technological University (NTU) have developed an ultra-fast charging battery – so fast that it can be recharged up to 70 percent in only two minutes.

When comparing this new discovery to the already existing lithium-ion batteries, the new generation has a lifespan of over 20 years – approximately 10 times more than the current lithium-ion battery. Further, each of the existing li-ion’s cycles takes two to four hours to charge, which is significantly more than the new generation’s two minute charge time.

The development will be of particular benefit to the industry of electric vehicles, where people are often put off by the long recharge times and limited battery life. The researchers at NTU believe that drivers of electric vehicles could save tens of thousands on battery replacement costs and will be able to charge their cars in just ten minutes, all in thanks to the new ultra-fast charging battery.

This from NTU:

In the new NTU-developed battery, the traditional graphite used for the anode (negative pole) in lithium-ion batteries is replaced with a new gel material made from titanium dioxide. Titanium dioxide is an abundant, cheap and safe material found in soil. It is commonly used as a food additive or in sunscreen lotions to absorb harmful ultraviolet rays. Naturally found in spherical shape, the NTU team has found a way to transform the titanium dioxide into tiny nanotubes, which is a thousand times thinner than the diameter of a human hair. This speeds up the chemical reactions taking place in the new battery, allowing for super-fast charging.

Read the full article here.

If you’re interested in battery research, take a look at what our Battery Division has to offer.

You can also explore the vast amount of research ECS carries on the technological and scientific breakthroughs in the field of battery by browsing through our digital library or taking a look at this past issue of Interface.

Sadoway’s research seeks to establish the scientific underpinnings for technologies that make efficient use of energy and natural resources in an environmentally sound matter.
Credit: MIT

Donald R. Sadoway – a prominent member of The Electrochemical Society and electrochemist at the Massachusetts Institute of Technology in Cambridge – has led a team of researchers at MIT to improve a proposed liquid battery system that could help make sources of renewable energy more viable and prove to be a competitor for conventional power plants.

This from MIT News:

Sadoway, the John F. Elliott Professor of Materials Chemistry, says the new formula allows the battery to work at a temperature more than 200 degrees Celsius lower than the previous formulation. In addition to the lower operating temperature, which should simplify the battery’s design and extend its working life, the new formulation will be less expensive to make, he says.

(more…)

Join the ECS LinkedIn group.

This from our LinkedIn group:

Recently some researchers move to Mg batteries. Pellion Tech in its white paper claims double energy density both in volumetric and gravimetric for Mg batteries.

I am confused since it seems that the discharge voltage should be at least 3V and no cell have been reported working experimentally at such potential yet (Maybe I did not find).

Moreover, the safety issues will not come for Mg batteries with magnesium anodes? and for Mg-ion batteries, the energy density would be competitive with current Li-ion batteries?

Does the main opportunity for Mg batteries lie in their cathodes same as Lithium batteries?

Leave comments here.

Request to join the LinkedIn group today!

This focus issue will cover state-of-the-art efforts that address a variety of approaches to printable functional materials and devices.

Printing technologies in an atmospheric environment offer the potential for low-cost and materials-efficient alternatives for manufacturing electronics and energy devices such as luminescent displays, thin film transistors, sensors, thin film photovoltaics, fuel cells, capacitors, and batteries.

Significant progress has been made in the area of printable functional organic and inorganic materials including conductors, semiconductors, dielectric, and luminescent materials

These will enable exciting advances in printed electronics and energy devices. Some examples are printed amorphous oxide semiconductors, organic conductors and semiconductors, inorganic semiconductor nanomaterials, silicon, chalcogenide semiconductors, ceramics, metals, intercalation compounds, and carbon-based materials.

This focus issue will cover state-of-the-art efforts that address a variety of approaches to printable functional materials and device. The focus issue will include both invited and contributed papers reflecting recent achievements. Prospective authors are encouraged to submit contributions reporting the original research results or reviewing key emerging trends in printable functional materials and devices for publication in this focus issue.

Find out more.

ECS members are now eligible for a special discounted rate on EL-CELL’s seminar programs. The first, a hands-on seminar on basic battery research will be offered November 6 & 7, 2014 at the EL-CELL facility in Hamburg, Germany. The second, a hands-on seminar on advanced battery research will be offered March 12 & 13, 2015, also in Hamburg, Germany.

Johannes Hinckeldeyn, Director of Sales and Marketing at EL-CELL, explains the strong collaboration with ECS, “EL-CELL wants to become the standard toolbox for all battery researchers. ECS is the global organization of Electrochemists and therefore our main partner to support electrochemists who want to achieve better research results. Beside our equipment, we offer special seminars for beginners and experienced researchers to learn how to conduct successful battery tests with our equipment. ECS members are cordially invited to participate and they will get special conditions for our seminars.” Please visit www.el-cell.com/service for registration and further information.